20KW Generator Maintenance Schedule with “Build 84” Lister-Petter Engine (in normal environments)

HOURS

Change Oil and Fuel Filters after first 100 hours of operation then at the following intervals:

Normal environments refer to operation of the generator in normal conditions. Air quality, fuel quality, temperature and load all affect service frequency. Airborne containments will affect the air filter and radiator service requirements. Poor fuel, either from the source or due to storage, will affect the fuel filters. Load, either excessive or minimal, will affect the lube oil requirements. Inspection and testing are extremely important. If you have a question about performance, test unit with a load-bank.

Resetting time to service clock on LitePOWER Generators, 20kw to 200kw, with the single phase/three phase switch. Turn POWER ON and hold the RTM switch in the up position until the information has scrolled through it’s third repeat. This will reset the TIME TO SERVICE clock to 200 HOURS.

If the generator is equipped with a 480-volt position on the phase switch the instructions are the same with this exception; the AUTO/OFF/RUN switch must be in the AUTO position.

PART NUMBERS